Z Collection DC Motor     

 

Electricity: 55kw- 1600KW

Voltage: standard 400V, 440V, 660V

Pace: rated velocity reference

Defense Degree: IP23/IP44

Insulation Class: F

Duty: S1

Bundle: export wood bundle

Payment: thirty% in progress, harmony by T/T or L/C at sight

 

Z355-4A, 375KW, 550V, 1220r/min, IC06, IP23/IP44, F Insulation

 

CZPT

 1. The strategies and security degree of the motor

a) The strategy of cooling of the motor is independently-cooled, according to GB/T1993 “Technique of cooling of rotating electrical equipment”, there are IC06, IC17, IC37, IC86W. CZPT entrance of cooling air is at the end of the major transmission(not the commutator side). The security course of the motor can be divided into IP23 and IP44 according to the GB/T4942.one and IEC34-5. If the user requirements other method of cooling and defend class, it can be negotiated.

b) the relation between the strategy of cooling and the security diploma of the motor pls see

Desk 1.

 c) the cooling strategy, wind stress, cooling water flux, motor power see: Table two.

Body	Built-on blower				air-to-drinking water heat exchanger
	cooling wind	Wind pressure (whisht stress)	motor energy	fat	Cooling drinking water flux	motor power	bodyweight
	m³/hr	Pa	KW	KG	m³/hr	KW	KG
H500	ten thousand	1900	seven.5	300	19	11	900
H560	16500	2250	fifteen.	four hundred	22	eighteen.five	1100
H710	23500	2400	18.5	600	forty	2*11	1600

2. The set up and the kind of motor according to the GB/T997 “the composition and installation sort of rotating electrical equipment”, have IM1001(Horizontal base install, column biaxial) and IM1002 (Horizontal base set up, column biaxial). If the user wants other types of installation construction, it must be negotiated.

three. The position of terminal box on regular motor is on the appropriate aspect when viewing from the principal push stop. It can also be mounted on the left aspect, but it need to be prepared in the purchase contract.

four. The motor using rolling bearing, nonstop incorporating oil framework.

5. The motor can be installed the subsequent components at the user’s alternative.

a) temperature detector component can be place into stator winding and bearing space of two aspect, and connect the outlet wire to the terminal box.

b) The non-travel celebration of the machine can outfitted with tacho-generator, centrifugal starting up swap, coder and other individuals which develop up the pace meter safeguarding unit.

c) Heater for protecting against condensation can be mounted in the motor, but it should be composed in the other speak to

six. The air-to drinking water heat exchanger is normally put in on the top of the motor. If the consumer desires to be put in on the aspect of the motor, the person need to set CZPT it when ordering and settle the assistant upholder by the person himself.

seven. The cooler geared up with wind stress change, temperature controller, heater for stopping condensation and pther defend unit.

 

Order notice

one. The motor type, power, voltage, running speed, excitation type, cooling type, number of output draft, position of outlet box, etc. Must be written when ordering.

2. Pls give clear indication of the accessory’s type, specification and number installed on the motor when ordering.

3. If the environment of using is special, humid torrid zone type motor is needed pls write “H” after the original type.

4. If you have some special requirement of the specification and technical requirement which is not listed in the booklet, pls contact us.

Packaging & Shipping and delivery

Tests Gear